山東山汽工程機械(集團)有限公司
熱線電話:400-879-1999 山汽官方微信
鄭重聲明 購機 售后
在線詢價
熱線電話:400-879-1999
您現在所在的位置: 首頁> 新聞資訊 > 公司新聞 >

自動上料攪拌機如何重載試運轉?

所屬分類:公司新聞 發布時間:2020-06-05 來源:http://www.whjchh.com 瀏覽量:18

  你知道在運輸重負荷混凝土時,自動上料攪拌機是如何測試運行的嗎?步驟如下。
  Do you know how the automatic loading mixer is tested and operated when transporting heavy-duty concrete? The steps are as follows.
  1. 根據所需的混凝土比確定供水,并將時間繼電器調整到相應的供水時間。
  1. Determine the water supply according to the required concrete ratio, and adjust the time relay to the corresponding water supply time.
  2. 啟動攪拌電機運轉。
  2. Start the mixing motor.
  3.將所需的混合物加入料斗后,關閉卸料門,提起料斗。料斗運行平穩,可自由停在軌道的任何位置。待料斗起升正常、制動可靠后,將料送入攪拌槽,啟動水泵,向攪拌槽供水。
自動上料攪拌機
  3. After the required mixture is added to the hopper, close the discharge door and lift the hopper. The hopper runs smoothly and can stop at any position of the track freely. After the hopper rises normally and the brake is reliable, feed the material into the mixing tank, start the water pump and supply water to the mixing tank.
  4. 攪拌25-35秒后啟動出料門。
  4. Start the discharge valve after mixing for 25-35 seconds.
  5. 在上述試運轉過程中,如發現異常情況,應立即停機檢查排除故障,然后再試運轉至正常。
  5. During the above test run, if any abnormal condition is found, stop the machine immediately to check and eliminate the fault, and then try to run it to normal again.
  自動上料攪拌機的重載試運行如上所示。車輛在重載條件下進行試車是非常必要的。司機必須注意這一點。
  The heavy load trial operation of the automatic feeding mixer is as shown above. It is necessary to test the vehicle under heavy load. The driver must pay attention to this.
熱門產品 / HOT PRODUCT

 

首頁 產品 電話 置頂
99视频在线精品国自产拍亚瑟|bt天堂在线 男人影视|秋霞A级毛片在线看理论片|亚洲日韩欧美在线无卡